The pump is then idle until the water level rises again.
Tethered float switch adjustment.
Attach the float switch to the top of the pump.
Step by step disconnect from power.
Efore tightening adjust tether length.
Next manually or electronically adjust the float switch up or down based on the water level in.
The float switch through at least two complete cycles.
Rod settings are made by sliding the sump float up and down the desired.
Pump sold separately.
When the float rises to a pre set height the pump will be switched on.
Tether length.
To order a pump for your diy grey water project email sales greywaterdiy co za south africa or click here to order from amazon.
Anytime you are working on your sump pump it should be disconnected from the power.
The pump will continue to operate until the float drops low enough to disengage the switch.
Test with bucket of water.
Make any necessary adjustments at this time.
Make sure the pump operates at the desired levels.